Skip Navigation
SBIR/STTR

Microwave Enhanced Freeze Drying of Solid Waste, Phase I

Completed Technology Project

Project Introduction

Microwave Enhanced Freeze Drying of Solid Waste, Phase I
Development of technology for Microwave Enhanced Freeze Drying of Solid Waste (MEFDSW) is proposed. The present state of the art for solid waste stabilization using lyophilization is very effective at removing water (up to 99.9%), but suffers from long processing times and high specific energy, because system equipment must operate continuously over the duration of the process. For conventional freeze drying operations, the system vacuum pump and the heat transfer system are in continuous operation. By utilizing microwave power to provide the necessary phase change energy to convert solid water to water vapor via sublimation at low pressure and temperature, the conductive heat transfer rate limitation that plagues conventional freeze dryers can be short-circuited. In addition, since the product quality of the dried solid waste is less of an issue than for food and pharmaceutical products, the sublimation envelope can be pushed. If the eutectic temperature is exceeded in localized regions in the solid waste during processing and partial melting to liquid water occurs in these regions, little significant impact, if any, will be made on the final state of the dried solid waste, but the rate of drying may be greatly accelerated, making the overall process more efficient. More »

Primary U.S. Work Locations and Key Partners

Project Library

Share this Project

Organizational Responsibility

Project Management

Project Duration

This is a historic project that was completed before the creation of TechPort on October 1, 2012. Available data has been included. This record may contain less data than currently active projects.

^