Skip Navigation
SBIR/STTR

Low Noise PAV Ducted Propeller using Automotive Manufacturing, Phase I

Completed Technology Project

Project Introduction

Low Noise PAV Ducted Propeller using Automotive Manufacturing, Phase I
A critical barrier for GA to serve as viable and volume personal transportation is the lack of a cost-effective, yet open-growth, Lean Design and manufacturing technologies using automotive manufacturing technologies in for new personal airplanes. Munro & Associate and Michigan SATS share a vision, ?The CAR of the FUTURE is an Airplane?. This STTR?s goal is to create an innovative, Lean Design PAV design through 21st century automotive industry technologies ? Such designs systems will serve as a vital enabler for turning NASA's PAV Vision into reality. More »

Primary U.S. Work Locations and Key Partners

Project Library

Share this Project

Organizational Responsibility

Project Management

Project Duration

Light bulb

Suggest an Edit

Recommend changes and additions to this project record.

This is a historic project that was completed before the creation of TechPort on October 1, 2012. Available data has been included. This record may contain less data than currently active projects.

^